Logo

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

Last Updated: 16.06.2025 16:26

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

but this device (an Inductor) … impedes the rapid changes in the current.

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

What type of sex do women prefer, oral, anal, or vaginal?

what exactly is a ‘surge’ protector?

These devices are installed between the “hot” and “neutral” and protective ground.

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

Why did Kakashi use Chidori against Rin, despite knowing about her feelings for Obito?

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

A fuse is a non-resetable over current circuit protector.

I always feel very tired after I do some exercises, even after a night's sleep. What's the problem?

This is where this question deviates from being a 'generic' question, and becomes more specific.

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

It also is a device that limits the change in current flow.

What is the Abu Shusha massacre in Palestine?

eight

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

What would be the lowest score with 9 strikes and no gutter balls?

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

An AC voltage/ current source, and an ac inductive load.

I post the exact comment here.

What is the dirtiest city in India?

(Dc diagram shown, AC is similar).

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

Now when you have a certain ac resistance, then a current flows in a loop.

Why do some people feel down in summer, specifically in July and August? What could be the reasons behind this feeling of sadness during those months only?

For this case there are devices called Metal oxide varistors (MOV).

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.

Here is a simplified AC power diagram.

What are some healthy ways to start losing weight without risking starvation mode or extreme food restriction?

He then asserts :

The other is “what does a “fuse” do?”

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

Why do some people refuse to explain their actions or behavior when asked? Why do they claim to not know the reason instead of providing an explanation?

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”

There are two important concepts here.

What will the legacy of Jimmy Carter be in light of his death today at 100?

In schematic diagrams this is the symbol for a fuse:

the problem then depends on "how fast does the fuse operate?".

nine

What is the most heartbreaking thing your child has told you?

So, the voltage could go up to 500 volts, and the fuse will not open up.

so, what happens?

But… the neutral is now “floating” because of the 1 ohm resistance.

What is one small habit that has transformed your life in unexpected ways?

This is where the MOV conducts again, and dissipated the energy.

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

Because the load is inductive, the current lags the voltage.(by a bit).

What are the major security challenges facing India, both domestically and internationally, and how does the government address them?

2024–10–14 [Omar Gharbi Omar Gharbi ]

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.

One

At one ohm, the resistor has a maximum of 1 watt power.

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.

The MOV will conduct when the voltage exceeds 50% of line voltage.

It seems Mohan does not understand the difference between a comment and an Answer.

One is “what exactly is in a ‘surge protector’ ? ”

The third is lightning and “how it gets conducted into a home.”

Edit 2024–10.

This one hit behind the barn.

The bolt then partially travels down the line to your home.

[image of Common-mode choke]

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

Upvotes:

At least they know the answer if they wanted it.

Barnstars:

Can the fuse protect the electronic devices from lightning instead of a surge protector.

a photo is worth a thousand words.

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

[old diagram got deleted by accident]

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

These are simplified answers to the original question, and does not change anything I wrote above.

There are three different concepts here that are getting confused.

This device then solves the entire problem.

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi

First Sentence:

What is lightning?

2024–10–16 [ OO OLAOYE OYEBODE ]

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

A circuit breaker is similar, but is resettable.

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

He then describes the function of a fuse.

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

What does a fuse do?

But it can get overloaded, and no longer works.

2024–10–10[John johnson John Johnson ]

This is the picture of an electronic coil of wire wound around a core of magnetic material.

He then describes Rainy Season and Lightning.

but I think this circuit , shows a few more pieces.

This is 'the assistant's answer'

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.